How to make RC Airplanes: How to make a rc air plane Cessna 150

How to do rc airplane Cessna 150.

The Cessna 150 it’s RC Electric Foam Aircraft. I designed and built it from deprone.

Motor 2205C 1400Kv Brushless motor
3 servo HXT500 5g / .8 kg / 10sec Micro Serv
1 servo HXT900 9g / 1.6kg / .12 sec Micro Servo (for elevator)
Speed Controller SuperSimple 18A ESC
Battery ZIPPY Flightmax 1000mAh 2S1P 20C
Prop GWS 8x6 or 9x4.7

You can download plans for Cessna 150 from here or here.

Print the drawings and cut piece from deprone.

I used double-sided sticky tape for joining the keel and rudder.

Also fixed а elevator.

Plaster with a thin layer of glue all around the adhesive tape and pressed the second part.

Skeleton of Cessna 150.

Skeleton of RC model airplane Cessna 150

Glue the keel to the sidewall of the fuselage.

And a nasal lining.

Glue the second side of the fuselage and the lower and upper part.

Production of a wing model aircraft.

rc model Longeron for wing

Cut the back of the wing.

Fixes it.

glue spar for rc air model

And glue spar.

fixes it

Now glue the back edge of the wing.

Making the edge of the wing

part of airmodel do rc aircraft

Glue a V part spar into one console of wing.

And look at the model aircraft

Part 2. Install electronic in RC model Cessna 150.

Servo for rudder.

Servo for elevator.

Glue it.

Connect rudder and elevator into servos.

Cut a aileron.

Servo for the aileron.

For mounting the ailerons, I used colored tape.

Glue the wing.

On top of the wing put the pad width 115 mm. Now glue the wooden sticks on the front and rear edge. This is to ensure that the gum would not selling the wing model aircraft.